Table of Contents
Advertisement
Switch (Key) Functions
Note that location 56 is factory defaulted to '0' for control panel only. This keeps the communicator off until location
56 is changed to '1' for slave communicator or '2' for panel/communicator. Once location 56 is set to '1' or '2' and a
valid phone number is entered, entry into the Program Mode will cause transmission of the 'system off-normal' report.
Throughout Program Mode, the first three locations on the left of the display represent the memory address which can
range from 000 to 313 (alpha characters are not used). The last location (farthest right) represents the contents of the
memory address. The first address displayed is shown below:
3.2
Switch (Key) Functions
The function of each switch (key) in Program Mode is shown below.
Control Panel Keypad
FIGURE 3-1:
Address entry keys are 0 to 9
Data entry keys are 0 to 9 and A to F
3.3
Programming Options
Primary Central Station Phone Number (00-15)
The first sixteen addresses, 00-15, are factory set to 'F' (from 00_F to 15_F). Programming is typically done as
follows: If the phone number to be entered is 484-7161, press the 4 key. The display will read 00_4. Press the
[ENTER/STORE] key to save the entry to memory and increment to the next address 01_F.
Enter the remaining numbers in their respective addresses as shown below:
4
8
4
7
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15
Valid entries for both the primary and secondary phone numbers are 0 - F with the numeric digits as dialed numbers
and the alpha characters representing the following functions:
A = * on a Touchtone phone keypad
B = # on a Touchtone phone keypad
C = look for secondary dial tone for up to 2 seconds (then dial anyway)
D = three second pause
E = five second pause
F = end of phone number ('F' must be entered)
32
00_F
(address)(data)
1
6
1
F
F
F
F
Document #50066
No function in Program Mode
F
F
F
F
F
Rev.D2
12/03/02
P/N 50066:D2
- Select operating mode
- Increment memory address
- Decrement memory address
- 1st press - first memory address
- 2nd press - type any address
- Save data, and increment address
Hide quick links:
Advertisement
Table of Contents
