Antec Mini P180 White User Manual page 4

Note: Please check your motherboard manual for your USB header pin layout and
make sure it matches the table below.
1 2
9 10
Connecting the eSATA Port
This case comes with an eSATA port in the front of the case to connect to your
external SATA devices. You will find a SATA connector on a cable attached to the
front eSATA ports. Connect it to a SATA connector on your motherboard.
Connecting the Audio Ports (AC'97 and HDA)
There is an Intel standard 10-pin AC'97 connector and an Intel 10-pin HDA (High
Definition Audio) connector, you can connect either of them to your motherboard
depending on the specification of the motherboard. See instruction below:
10 6 4 2
9 7 5 3 1
Note: Please check your motherboard manual for your audio header pin layout and
make sure it matches the table. Even if your system supports both audio standards,
you may only connect one connector, not both.
Installing the Drives
With the front bezel facing you, swing the front door out. It can swing 270
degrees so the door will be parallel with the side of the case. You can see one
5.25" external drive bay at the top and two 5.25" drive bays at the bottom of the
Motherboard Pin Layout
Pin Signal Names
1
USB Power 1
3
Negative Signal 1
5
Positive Signal 1
7
Ground 1
9
Key (No Connection)
Pin Assignment for Audio Ports (HDA and AC'97)
Signal Names
Pin
1
2
3
4
5
6
7
8 Key (no pin)
9
10
(HDA)
MIC2 L
AGND
MIC2 R
AVCC
FRO-R
MIC2_JD
F_IO_SEN
FRO-L
LINE2_JD
3
Pin Signal Names
2
USB Power 2
4
Negative Signal 2
6
Positive Signal 2
8
Ground 2
10
Empty Pin
Signal Names
Pin
(AC'97)
1 MIC In
2 GND
3 MIC Power
4 NC
5 Line Out (R)
6 Line Out (R)
7 NC
8 Key (no pin)
9 Line Out (L)
10 Line Out (L)