Schwinn MPower Console V2 + Power Owner's Manual page 21

Replacing the Power Sensor Battery
This procedure is only for bikes that have the Power Sensor upgrade installed.
If you need to replace the batteries in the Power Sensor, refer to the Schwinn® MPower™ Power Upgrade Installation Guide:
• • •
Remove the 2 screws that attach the Power Sensor to the Brake Carriage.
• • •
Remove the gasket from the outer sensor housing.
• • •
Remove the old battery from the battery bay.
• • •
Put the new battery in the battery bay. Make sure that it points in the correct direction (+ and –).
• • •
Put the gasket back on the outer housing .
• • •
Attach the Power Sensor to the Brake Carriage with the 2 screws.