Schwinn MPower Console V2 + Power Owner's Manual page 20

Replacing the Speed Sensor Battery
If you need to replace the batteries in the speed sensor:
• • •
Remove the 2 screws that attach the speed sensor to the front of the chainguard.
• • •
Remove the small screw that attaches the inner sensor housing to the outer housing.
• • •
Slide the inner housing off the outer housing. The battery holder is in the inner housing.
• • •
Carefully slide the old battery out of the battery holder.
• • •
Carefully slide the new battery into the battery holder. Make sure that you can see the + icon on the battery.
• • •
Install the inner sensor housing to the outer housing with the small screw.
• • •
Attach the sensor to the chainguard with the 2 screws.
20