Usb Interface - BT SG300 Quick Manual

3.2.2 USB Interface

A. Turn off the host device.
B. Connect the 10-pin RJ45 male connector
into the 10-pin modular jack on the bottom of
the charger cradle.
C. Connect the USB A type connector to the
USB port on the host device.
D. Plug the power supply into the power jack on
the bottom of the cradle.
E. Plug the power supply into the AC outlet.
The red LED on the rear of the cradle will
stay on.
F. Turn on the host device.
G. Establish communication between the
scanner and cradle.
7