Cleaning And Maintenance; Troubleshooting; Specification Chart - Linea DH-360 Instruction Manual

Cleaning and maintenance of your machine
The most expensive part of a laminator is usually the rollers, if these become
damaged they are costly to repair. Always ensure you look after the rollers and
clean them regularly to avoid a build up of glue (see advice below). Never hold
a sharp object such as a knife close to the rollers in case of catching the rubber
as this could cause permanent damage that will effect the result of your work.
When your laminator is cooling down, always separate the rollers using the roller
pressure knob, this will ensure that your rollers do not touch when still hot as
this could leave a 'flat spot'.
Cleaning the rollers
It is easier to remove adhesive from the rollers when they are warm, do not
attempt this if the machine is hot (above 40
safety shield and feed tray. Always use a clean cloth and a mild anti-static foam
cleaner such as Amberclens by Ambersil or similar, do not use a heavy duty
solvent or anything abrasive.
If the film becomes jammed in the machine in any way and there is a large build
up of adhesive, do not try and remove this yourself, contact your supplier for
advice.

Troubleshooting

My laminator has no power
Make sure that the electrical outlet being used is not damaged and that it is supplying power. Ensure the power cord
is firmly fitted in the back of the machine and not straining in any way. If all of this seems correct, there are three
fuses to check, one is located next to the power switch, the other two are located underneath the laminator.
Contact your supplier if none of these solutions resolve the problem.
My lamination is coming out cloudy
This means that the temperature is not hot enough, try and increase by 5
the new temperature before putting through another print.
My lamination has come out wrinkled/creased
This means that the temperature is too hot. You should also put a test document through first to avoid ruining your
work. Reduce the temperature by 5
The film is wrapping around the rollers when I try to laminate
The film may be threaded incorrectly, refer to the threading diagram on page 6 or 8 (depending on if you are doing
single sided or encapsulating. The adhesive side of the film may be facing the roller. Stop the operation, wait until
the laminator has cooled down and thread the film again in the correct manner.

Specification chart

MODEL
MAX LAMINATING WIDTH
MAX LAMINATING THICKNESS
MAX LAMINATING TEMPERATURE
MAX LAMINATING SPEED
RECOMMENDED FILM
DIAMETER OF HEATING ROLLER
DIAMETER OF PULL ROLLER
POWER SUPPLY
POWER
DIMENSIONS
WEIGHT
STAND
o
C). For easy access, remove the
o
C and wait until the laminator has cooled before trying again.
DH-360
340mm
5mm
140 o C
1.4m/min
BOSS film, up to 250 micron
44mm
30mm
700W
620 x 420 x 310mm
30kg
N/A
o
C and wait until the laminator has reached
DH-460
460mm
5mm
140 o C
1.4m metres/minute
BOSS film, up to 250 micron
55mm
45mm
100, 110, 220-240V, 50, 60Hz
950W
720 x 520 x 400mm
45kg
N/A
DH-650
650mm
5mm
140 o C
1.4 metres/minute
BOSS film, up to 250 micron
55mm
45mm
1600W
910 x 520 x 400mm
58kg
Optional Extra
9