Water Tank Lid; Before Use - Espressotoria Adesso Operating Instructions Manual

Before use

Congratulations!
This ESPRESSOTORIA® System ADESSO Automatic coffee
capsule machine is a first-class product, manufactured
with the greatest care. If you look after it properly it will
reward you with many years of good service.
After unpacking, please check that the following parts are included:
Power cable
1x water tank lid
Caution
• Check that your power supply voltage is the same
as marked on the machine rating plate (220-240 V).
• Destroy all the plastic bags to prevent danger to
children!
1.
Before using for the first time
Thoroughly rinse out the water tank with hot water
before using for the first time. Clean the capsule coffee
machine using a damp cloth only (see 11. Cleaning the
appliance).
Caution
• Danger of tripping! Do not let the power cable
hang down.
• Danger of electric shock! Never clamp or run the
power cable over sharp corners or edges or hot
surfaces.
• To make sure that the machine is switched off,
switch the power point off and remove the plug
from the power point.
• Danger of scalding: beware of hot water.
• Do not operate the machine with an empty water
tank.
• Always pull out the power plug before cleaning the
machine.
Before using your new machine, please read this op-
erating manual carefully, keep it safe and pass it on to
the next user. For further information please contact
the service and sales centre.
ESPRESSOTORIA®
System ADESSO
Automatic coffee
capsule machine
The machine location must meet the following require-
ments:
• Place the machine on a dry, stable and level surface, not
• Never place the machine or power cable on or nearer
• Never place the machine nearer than 60 cm to the wash
• If you need an extension cable, make sure it is suitable
• Remove the protective foil from the perforated drip tray
Perforated drip
tray cover
Two-piece
drip tray
Note
• There can be remaining water in the tank from the
function testing before leaving the factory.
• Coffee capsules are not included!
2.
Installation / Power connection
directly under the power point. Only use the machine in
a dry room.
than 50 cm to hot surfaces or open flames.
basin.
for your machine (3-pole grounded, 1.5 mm² conductor
cross-section).
cover and insert it in the drip tray.
Note
Before using the machine for the first time the
internal piping must be flushed out (for details see: 9.
Flushing machine and internal piping).
Used
capsules
container