Operating Lever; Dispensing Button; Troubleshooting - Espressotoria Adesso Operating Instructions Manual

Troubleshooting

Problems and their remedies
Repairs to your machine may only be carried out at the ser-
vice centre. Unprofessional repairs and use of non-original
replacement parts can be dangerous for the user.
In case of unprofessional repairs, no liability will be accept-
ed for resultant damage and the guarantee is invalidated.
Problem
No coffee output or
insufficient output
No coffee output
Cold coffee
Pump sounds very loud
Water drips continuously
out of dispensing head
Occasional drops drip
out of dispensing head
Coffee tastes sour
The amount of water
programmed per cup is
not correct

Dispensing button

flashes red very quickly
Dispensing button
lights up in green
The machine stops
dispensing
The lever can not be
lowered
Dispensing button
flashes green very
quickly
Possible cause
water tank empty
defective pump
capsule not (completely) perforated
operating lever open
scale built up in the machine
water tank not properly in place
defective pump
heating system defective
water tank empty
water tank not properly in place
machine /piping blocked with lime
deposits
empty capsules have remained in the
boiler unit
machine not flushed out enough after
descaling
capsule has passed expiration date
water tank empty
program changed
water quantity dosage not program-
mable
electronic malfunctioning
no malfunctioning. The machine is in
energy saving mode
water tank empty
defective pump
the used capsules tray is full
capsule stuck inside
machine is exposed to cold tempera-
ture for prolonged time, the heating
function is disabled for safety reasons.
If this troubleshooting guide does not help you solve your
problem, please contact your local sales point.
Important: pull out the power plug immediately in case
of faults, defects or possible damage to the machine after
a fall.
Remedy
fill the water tank
contact the service centre
use a new capsule/contact the service centre
close lever completely
descale the machine
insert water tank correctly
contact the service centre
contact the service centre
fill the water tank
insert water tank correctly
descale the machine
eject the capsule (occasional drops are normal,
it is not a defect)
flush out the machine again
use a new capsule
fill the water tank
reprogram
contact the service centre (for safety reason,
dispensing stops after 30 seconds)
switch off the machine, wait for 20 minutes
and restart it. If the problem persists, contact
the service centre
press one of the dispensing buttons
fill tank with fresh water
contact the service centre
empty the used capsule tray
remove the used capsule
switch off machine, wait until it reaches room
temperature and restart. If the problem per-
sists, contact the service center.