Toshiba Satellite E200 Maintenance Manual page 166

4 Replacement Procedures
2. Remove the HDD pack by pulling on the tab attached to the pack.
NOTE: Do not disassemble the HDD pack when it is working normally. Disassemble or
replace the HDD pack only if it fails.
3. Place the HDD pack on a flat surface (such as a desk), and remove the four M3x4
black flat head screws.
4. Place the HDD pack on a flat surface (such as a desk), and remove the chassis.
M3x4 black flat
head screw
CAUTION: Do not apply pressure to the top or bottom of the drive.
4-24
HDD
Figure 4-11 Removing the HDD chassis
M3x4 black flat
head screw
HDD chassis
Satellite/E200/E205 Maintenance Manual
4.8 HDD