4.5 Display Assembly
4.5
Display Assembly
Removing the Display Assembly
Remove the display assembly according to the following procedures and Figures 4-7.
1. Open the display panel at an angle of 90 degrees.
2. Turn the computer upside down.
3. Disconnect the CCD cable from CN2250 on the system board.
4. Disconnect the MIC cable from CN208 on the system board.
5. Disconnect the LCD cable from CN3000 on the system board.
6. Remove two M2.5x4 black flat head screws securing the LCD module to the top
cover.
CN3000
LCD cable
Satellite/E200/E205
Maintenance Manual
.
M2 5x4 black flat head screw
Figure 4-7 Removing the display assembly
4 Replacement Procedures
CN208
CN2250
CCD cable
MIC cable
4-17