Replacement Procedures
Install an optical disk drive
The following describes the procedure of installing an optical disk drive (See Figure 4-12 and
4-13).
1. Attach the ODD bracket to an optical disk drive and secure it with the following screws.
• M2.0×3.0 Flat BIND screw
2. Insert an optical disk drive assembly into the slot and connect it to the connector CN26
on the system board.
3. Secure the ODD drive with the following screw.
• M2.5X4.0
4. Secure the Memory Module Cover with the following screw.
• M2.5×4.0B
Satellite M300 and Satellite Pro M300 Maintenance Manual (960-Q08)
Figure 4-15 Disassemble the side bracket
Flat BIND screw x 1
BIND screw
4-29
ODD bracket 3
Screws
x 3
x 3