Jensen MP6312 Instruction Manual page 7

MP6312i
WIRING
NOTE: The amplifier in this
radio is only designed for use
with four speakers. Never
combine (bridge) outputs for
use with two speakers. Never
ground negative speaker
leads to chassis ground.
Failure to wire exactly as
shown may cause electrical
damage to the radio.
NOTE: Only connect speakers
with a nominal impedance of 4
ohms. Speakers with a load
impedance less than 4 ohms
could damage the unit.
MediaLink Connector
Antenna
Connect the antenna plug
from the existing antenna
cable (some vehicles
require an adaptor).
Satellite Radio Audio In
3.5mm 3.5mm
Audio Only
Audio Only
iPod Video iPod iPod Mini iPod Nano
jLink iPod Cable
(Sold Separately)
Ground
Connect to ground terminal
or clean, unpainted part of chassis.
Black
Memory/Battery
Connect to battery or 12 volt power
source that is always live. The radio will
not work if this wire is not connected.
Yellow
FRONT SP
White/Black White Gray/Black Gray
Stripe Stripe
Left Speaker Right Speaker
(Front) (Front)
5
Satellite Radio In
Fuse (15 amp fast blow ATO)
Rear Line out
Gray
Front r Line out
Black
Power Antenna
Connect to power antenna or amplifier.
If not used, tape bare end of wire.
Blue
Accessory/Ignition
Connect to existing radio wire
or radio fuse.
Red
REAR SP
Green/Black Green Purple/Black Purple
Stripe Stripe
Left Speaker Right Speaker
(Rear) (Rear)
R (Red)
L (White)
R (Red)
L (White)