Advertisement
5. Switch the heater to one of the three power settings:
C307 – 500W (I), 1000W (II), 1500W (I & II)
C309 - 800W (I), 1200W (III) & 2000W (I & II)
C3011T - 1000W (I), 1300W (II) & 2500W (I &II)
6. The operating temperature is selected by adjustment of the thermostat.
7. To determine the correct operating temperature for you conditions, when you
first switch the unit on set the thermostat to the maximum position. When the
unit reaches the required temperature, slowly turn down the thermostat, until the
unit switches off. The temperature will now be kept constant. When the
temperature falls the unit will come on again.
TIMER SETTING ON C0311T ONLY
The heater will be always on when the slide switch is in TIMER position (I).
The heater will be always off when the slide switch is in TIMER position (0).
The timer operates when the slide switch is in TIMER position (
To set the timer, rotate the clock dial clockwise, until the current time is aligned
with the indicator arrow at the centre.
When you wish the heater to switch ON, push the corresponding time segment
outwards from the centre. Each segment represents around 15 minutes. For
example, if you want the heater continuously ON for 2 hours, push 8 segments
outwards the centre face.
NOTE: The dial turns CLOCKWISE ONLY. Forcing the clock face
in the other direction will destroy the timing gear. The timer will stop
functioning when unplugged or during a power failure, The correct
time must be reset when power is restored.
SAFETY OVERHEAT SHUT OFF
A thermal overload protector is built in to prevent overheating. When a
potential overheat temperature is reached, the heater will be automatically
shut off. It can only resume operation when the user resets the unit.
RESET THE HEATER
1. Push the Power Switch to the OFF position.
2. Unplug the heater and wait 5-10 minutes for the unit to cool down.
3. Inspect and remove any objects on or adjacent to the heater that may
cause high temperature.
4. After 5-10 minutes, plug the unit in again and operate normally.
CLEANING
Before cleaning turn the heater turn off and unplug from the power supply.
To clean use a soft cloth to wipe off any dust. If the heater is very dirty use a
damp cloth and wipe dry. Do not use any cleaning detergents, sprays or
other chemicals, as they will damage the heater. Store in the original
packaging in a ventilated dry area, during off season use.
Caution: Do not allow water to run into the interior of the heater as this
could cause a fire or electric shock. DO NOT attempt to repair this heater
yourself.
SPECIFICATIONS
).
Model
C307
C309
C3011T
* Wattage will vary dependant on power
Power
Voltage
1500W
230V~ 50Hz
2000W
230V~ 50Hz
2500W Max
230V~ 50Hz
N.W. kg
G.W. kg
11.00
12.20
13.20
14.60
15.40
17.00
Advertisement
