Advertisement
IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THIS
PRODUCT.
Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause a fire or electrical shock.
When using electrical appliances, basic safety precautions should always be
followed:
1.
Before operating the heater remove the unit from its packaging and
check it is in good condition.
2.
The surfaces of this heater are hot whilst in operation. Always allow a
cool down period before moving it to another location. Keep all
flammable materials well away from the heater.
3 .
Extreme caution is necessary when any heater is used by or near children
or pets and whenever the heater is left operating and unattended.
4.
Always unplug heater when not in use.
5.
Do not operate any heater with a damaged cord or plug, after the heater
malfunctions, has been dropped or damaged in any manner. Return the
heater to an authorised service facility for examination and repair.
6.
Do not use outdoors. It is not intended for use in wet or damp locations.
Never locate heater where it may fall into a bathtub or other water container.
7. Do not run cord under carpeting. Do not cover cord with rugs or
runners. Arrange cord away from an area where it may be tripped
over. Do not use this heater with a programmer, timer or any other device that
switches the heater on automatically, since a fire risk exists if the heater is
covered or positioned incorrectly.
8. To disconnect heater, turn switches to the off position and remove plug from the
power socket. Pull only by the plug. Never pull on the cord.
9. Do not place the heater on soft surfaces. Always place on a flat level surface.
10. Do not use it in areas where petrol, paint, or flammable liquids are used or
stored.
11. Do not let children play with the packaging, for example plastic bags.
12. Check household voltage to ensure it matches the rating plate specification.
13. Avoid the use of an extension cord as it could overheat and cause a fire.
14. This heater is filled with a precise quantity of special oil. Repairs requiring
t h e opening of the oil container are only to be made by the
manufacturer or a qualified service engineer, who should be contacted if
there is any leakage.
READ & SAVE THESE IMPORTANT INSTRUCTIONS
BS PLUG WIRING
Wiring Instructions: Should it be necessary to change the plug please
note the wires in the mains lead are coloured in accordance with the
following code:
BLUE - NEUTRAL
BROWN - LIVE
GREEN AND YELLOW - EARTH
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
1. The BLUE wire is the NEUTRAL and must be connected to the terminal
which is marked with the letter N or coloured BLACK.
2. The BROWN wire is the LIVE and must be connected to the terminal
which is marked with the letter L or coloured RED.
3. The GREEN/YELLOW is the EARTH and must be connected to the
terminal which is marked with the letter E or
GREEN/YELLOW.
4. Always ensure that the cord grip is positioned and fastened correctly.
If a 13A (BS 1363) fused plug is used it must be fitted with a 13A fuse. If in
doubt consult a qualified electrician.
Wiring for a 13 Amp Plug (BS1363)
Please note. The Earth Terminal is marked with the letter E or Earth Symbol
or coloured GREEN OR
Advertisement
