Target Groups - A.O. Smith BFC-28 Installation, User And Service Manual

1
1.4

Target groups

10
Introduction
British and European Standards
• BS 6891:
Installation of low pressure gas pipework of up to 35 mm (R1¼) in domestic
premises (2nd family gas) - Specification. Note: for lager installations see
IGE/UP/2 below.
• BS 6798:
Specification for installation and maintenance of gas-fired boilers of rated
input not exceeding 70 kW net.
• BS 6644:
Specification for installation of gas-fired hot water boilers of rated inputs
between 70 kW (net) and 1.8 MW (net) (2nd and 3rd family gases).
• BS 6700:
Design, installation, testing and maintenance of services supplying water for
domestic use within buildings and their cartilages - Specifications
• BS EN 806-2:
Specification for installations inside buildings conveying water for human
consumption. Part 2: Design.
• BS 5546:
Specification for installation of hot water supplies for domestic purposes,
using gas-fired appliances of rated input not exceeding 70 kW.
• BS 5440:
Flueing and ventilation for gas appliances of rated input not exceeding 70
kW net (1st, 2nd and 3rd family gases).
Part 1: Specification for installation of gas appliances to chimneys and for
maintenance of chimneys.
Part 2: Specification for installation and maintenance of ventilation for gas
appliances.
Institute of Gas Engineers and Managers (IGEM) Publications
• IGE/UP/1:
Soundness testing and purging of industrial and commercial gas
installations.
• IGE/UP/1A:
Soundness testing and direct purging of small low pressure industrial and
commercial natural gas installations.
• IGE/UP/2:
Gas installation pipework, boosters and compressors on industrial and
commercial premises.
• IGE/UP/10:
Installation of flued gas appliances in industrial and commercial premises.
CIBSE Publications
• Guide G: Public Health Engineering.
The three target groups for this manual are:
• (end) users;
• installation engineers;
• service and maintenance engineers.
Symbols on each page indicate the target groups for whom the information is
intended. See the table.
gis
Instruction manual BFC