Table of Contents
Advertisement
9020/9030/9040 Environmental/Installation/PM
2-9
CAUTION
DO NOT TOUCH EDGE CONNECTOR OR FINSTRA TE PLANE.
HOLD FINSTRA TE BY EJECTORS OR SIDE EDGES ONLY. HAND-
LING FINSTRATE INCORRECTLY COULD CAUSE ELECTROSTA-
TIC DISCHARGE DAMAGE. WHEN INSTALLING FINSTRATE.
HOLD BY EJECTORS AND MOVE AIR CONTROLLER OUT OF
THE WAY WITH THE SIDE EDGE OF THE FINSTRATE.
7. (ALL - 2nd lOP)
Move all finstrates above slot 2 up one slot.
(ALL - 3rd lOP)
Move all finstrates above slot 3 up one slot (Slot 3 is first accessible finstrate without
removing door).
8. (520 - ONLY)
Remove cable clamp from processor stack door by removing two
#
1 Pozidriv screws.
9. (ALL)
Slide the lOP finstrate into the appropriate slot without seating fin strate into the mother-
board. Open the connector gate (Figure 3):
(2nd lOP) Slot 3.
(3rd lOP) Slot 4.
CONNECTOR GATE
lOP CABLE
CABLE CLAMP
IOP#2
DOOR CONNECTOR
REMOVED
Figure 3. Series 500 Computer lOP Installation.
Advertisement
Table of Contents
