Getting Started - LifeCore Fitness LC-R88 Rower User's Product Manual

Getting Started

Folding and Unfolding the Rower
Your Rower can be folded and unfolded in a matter of seconds. It is very important you understand
the operation of the Clamp Knob – Lock Pin for folding and unfolding your Rower.
Clamp Knob – Lock Pin
The Clamp Knob-Lock Pin is located under the monorail at the front of the Rower.
Rotate the knob until it is free enough to pull down to release the monorail. The lock pin will
automatically engage when the monorail is in the horizontal (ready to use) or folded position. You
will hear a "click" when the lock pin engages. Always tighten the clamp knob firmly before use, when
folded or before transportation.
Unfolding for Use
If the Clamp Knob is not tight when you start to use your Rower, the front of Rower will lift a little.
The lock pin will also prevent the Rower from accidently folding. When the clamp knob has been
firmly tightened, you can start your workout.
Folding the Rower
Important Note: Before starting the folding procedure, roll the seat forward to the Front Seat Stop.
Loosen the clamp knob and pull the knob down to release the lock pin. Slowly lift the monorail to the
fully folded position. You will hear the lock pin engage. For safety reasons, remember to tighten the
clamp knob. You should also fold the monitor down to avoid the chance of damage.
1) With the Rower in the flat position, rotate the Clamp Knob counterclockwise five to seven turns.
2) While holding the Aluminum Beam, pull the Clamp Knob down releasing the safety lock and
allowing the Aluminum Beam to be rotated up.
3) With the Rower in the folded position, rotate the Clamp Knob clockwise and tighten firmly.
Page | 6