Table of Contents
Advertisement
Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
AUTO
TEMP.
1. Press the MODE button to select Auto.
COOL
SET
DRY
2. Press the UP/DOWN button to set the
CLOCK
HEAT
HOUR
desired temperature. The temperature can
FAN
3
be set within a range of 62 F~86 F in 1 F
MODE
FAN SPEED
increments.
1
M
3. Press the ON/OFFbutton to start the
heat pump
2
NOTE
1. In the Auto mode, the heat pump can logically
choose the mode of Cooling, Fan, and Heating
by sensing the difference between the actual
ambient room temperature and the setting
temperature on the remote controller.
2. In the Auto mode, you can not switch the fan speed.
It has already been automatically controlled.
3. If the Auto mode is not comfortable for you , the
desired mode can be selected manually.
Ensure the unit is plugged in and power is
AUTO
available.
TEMP.
COOL
SET
1. Press the MODE button to select COOL, HEAT,
DRY
CLOCK
(cooling & heating models only) or FAN mode.
HEAT
HOUR
FAN
2. Press the UP/DOWN buttons to set the
4
MODE
FAN SPEED
desired temperature. The temperature can
1
M
3
be set within a range of 62 F~86 F in 1 F
increments.
3. Press the FAN SPEEDbutton to select the
fan speed in four steps- Auto, Low, Med,or
2
High.
4. Press the ON/OFF button to start the
heat pump
NOTE
In the FAN mode, the setting temperature is not
displayed in the remote controller and you are not able
to control the room temperature either. In this case,
only step 1, 3 and 4 may be performed.
Auto operation
O
O
O
Cooling /Heating/Fan operation
O
O
O
9 9
Dehumidifying operation
Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
AUTO
TEMP.
1. Press the MODE button to select DRY mode.
COOL
SET
DRY
2. Press the UP/DOWN buttons to set the
CLOCK
HEAT
HOUR
desired temperature.
FAN
3
be set within a range of 62 F~86 F in 1 F
MODE
FAN SPEED
increments.
1
M
3. Press the ON/OFF button to start the
heat pump
NOTE
2
In the Dehumidifying mode, you can not switch the
fan speed. It has already been automatically controlled.
Adjusting air flow direction
Use the SWING V button to adjust the desired
airflow direction.
When push the SWING V button, the horizontal
louver changes 6 degree in angle for each push.
Keep pushing more than 2 seconds, the louver
will swing automatically and give UP and
DOWN air flow.
NOTE: When the horizontal louver swing
10
10
The temperature can
O
O
O
or move to a position which would affect
the cooling or heating effect of the heat pump,
it would automatically change
the swing/moving direction.
Advertisement
Table of Contents
