Indicators On Lcd; How To Use The Buttons; Initial Setting The Clock - Pridom PFCM123HX Owner's Manual

Indicators on LCD

Mode display
Displays the current operation mode. Including
AUTO(
(Not applicable to cooling only models), FAN(
and back to AUTO(
Transmission Indicator
This transmission indicator lights when remote
controller transmits signals to the indoor unit.
ON/OFF display
Displayed by pressing the ON/OFF button.
Press the ON/OFF button again to remove.
Temp. display
Displays the temperature setting(62F ~86F /17C ~
O
30C ). When you set the operating mode to FAN, no
temperature setting is displayed.
AUTO
TEMP.
Time display
COOL
SET
Indicate Timer on/off time(0~24 hours) or clock
DRY
time. The clock time is indicated only when no AUTO-
CLOCK
ON/OFF timer is set. When AUTO-TIMER feature is
HEAT TIMER F F
operating, it displays the AUTO-ON/OFF time. To
HOUR ON OFF
check the current time, press the CLOCK button, and
FAN
the time will display.
Fan speed display
Displays the selected fan speed, AUTO(
fan speed levels "
"
is auto controlled under AUTO or DRY mode.
Lock Display
Displayed when LOCK mode is activated.
Sleep Display
Displayed under sleeping operation.
Press the SLEEP button again to remove.
I FEEL Display
Displayed when I FEEL function is activated.
Note:
All displays on the remote controller are
shown for illustration purposes only.
), COOL( ), DRY( ), HEAT( )
).
AUTO
O O O
) and three
" (LOW) " " (MED)
" (HIGH) can be indicated. The fan speed
7 7
)
AUTO
TEMP.
COOL
SET
DRY
CLOCK
HEAT TIMER
HOUR ON OFF
FAN
MODE FAN SPEED
M
SWING V SLEEP TIMER ON
TURBO
SWING H
TIMER OFF
I FEEL LED
SELF CLEAN CLOCK
RESET LOCK

How to use the buttons

Before you start operating the heat pump, set
the clock of the remote controller using the proce-
dures given in this section. The clock panel on the
remote controller will display the time regardless of
whether the heat pump is in use or not.

Initial Setting the Clock

After batteries are inserted in the remote controller,
the clock panel will display "12:00" and begin to flash.
1. UP/DOWN button
.
Press these buttons to set time.
1 Forward.
Backward.
.
Each time you press the button, the time moves
forward or backward by one minute depending
2
on which side you press. The time alters as quickly
as you push the button.
.
Keep pressing the button without releasing, the
time moves forward or backward by 10 minutes
depending on which side you press.
2. CLOCK button
When the right time is achieved, press the CLOCK
button or release the or and wait for 5
seconds, the clock time stops flashing and the
clock starts operating.
3.Readjusting the Clock
Press the CLOCK button on the remote controller,
the time of the clock display will start to flash. To
set the new time, follow 1 and 2 of "Initial Setting
of the Clock".
Note: The time of the CLOCK must be set before
the AUTO-TIMER feature will operate.
* Clock accuracy is within 15 seconds per day.
CAUTION
!
Static electricity or other factors (Voltage transients) can
cause the remote controller clock to initialize. If your
remote controller is initialized (the time of "12:00"
flashing), readjust the clock before starting the unit.
8 8