Table of Contents
Advertisement
Function buttons(continued)
When the I FEEL function is activated, the
remote display is actual temperature at its
location. The remote control will send this
signal to the heat pump every 3 minutes
AUTO
interval until press the I FEEL button again.
COOL
This indicator light
DRY
The I FEEL function is not available under
HEAT
DRY and FAN mode.
FAN
1
Switch the operation mode or turn off the unit
MODE
FAN SPEED
will cancel the I FEEL function automatically.
2
M
9
Under SELF CLEAN mode, the heat pump
10
will automatically clean and dry the Evaporator
11
and keep it as fresh for the next operation.
3
12
RESET Button
4
7
SWING V
SLEEP
TIMER ON
13
Once the recessed RESET button is pressed,
5
TURBO
14
SWING H
TIMER OFF
all of the current settings will be cancelled
6
I FEEL
LED
15
SELF CLEAN
CLOCK
and the controller will return to the initial settings.
7
16
RESET LOCK
LOCK Button
8
8
Press this recessed button to lock all current
settings, and the remote controller will not
accept any operation except that of the LOCK.
Use the LOCK mode when you want to prevent
settings from being changed accidentally.
Press the LOCK button again to cancel the
LOCK function. A lock symbol will appear on
the remote controller display when the lock
function is activated.
9
FAN SPEED Button
Used to select the fan speed in four steps:
AUTO
10
UP Button
Push this button to increase setting temperature
or to increase Hour during Clock time setting.
11
DOWN Button
Push this button to decrease setting temperature
or to decrease Hour during Clock time setting.
NOTE: Press and hold UP and DOWN buttons
together for 3 seconds will alternate the temper-
ature display between the C & F scale.
remains on.
LOW
MED
HIGH
O
O
5 5
12
TIMER ON Button
Press this button to activate the Auto-on time
setting. Each press will increase the time setting
in 30 minutes increments, up to 10 hours, then at
1 hour increments up to 24 hours. To cancel the
AUTO
Auto-on time setting, just press the button until
COOL
the time setting is 0.0.
DRY
HEAT
TIMER OFF Button
13
FAN
1
Press this button to activate the Auto-off time
MODE
FAN SPEED
setting. Each press will increase the time setting
2
9
M
in 30 minutes increments, up to 10 hours, then at
10
1 hour increments up to 24 hours. To cancel the
11
Auto-off time setting, just press the button until
3
12
the time setting is 0.0.
4
SWING V
SLEEP
TIMER ON
13
5
TURBO
13
TURBO
14
14
SWING H
TIMER OFF
6
I FEEL
Active/Disable Turbo function. Turbo function
LED
15
SELF CLEAN
CLOCK
7
enables the unit to reach the preset temperature
16
RESET LOCK
in the shortest time. When press this button
8
on heating mode(applicable to the unit adopts
PTC only), the PTC will be energized and bring
fast heating operation.
15
CLOCK Button
Used to set the remote clock.
LED Button
16
Disable/Active indoor screen Display.
NOTE:
Buttons design might be slightly different
from the actual one depending on individual
models.
All the functions described above are
accomplished by the indoor unit, if the
indoor unit has no this feature, there is no
corresponding operation happened when
press the relative button on the remote
controller.
Please do not select HEAT mode if the
machine you purchased is cooling only
type. Heat mode is not supported by the
coolingonly appliance.
6 6
Advertisement
Table of Contents
