Zenoah G230RC Owner's Service Manual page 9

7. Service Guide
Clutch Bolt
(14mm Hex.)
Rotor Nut
Puller Bolts
17mm Hex.
Rotor
Ignition Coil
Wrench
Air Gap Gauge
1) REMOVING CLUTCH SHOE
1. Remove the housing and plug cap.
2. Remove the spark plug and fit the
3. Remove clutch bolts(14mm Hex.).
2) REMOVING ROTOR (FAN)
4. Remove the rotor nut(12mm Hex.).
5. Remove the rotor using the puller assy (2890-
Puller
3) ASSEMBLING ROTOR
Insert the gauge(3330-97310) in between the
rotor magnet metal and the coil.Tighten screws
while pressing the coil against the rotor.
stopper(4810-96220) into the plug hole.
96100). Apply 8mm puller bolts.
Gap Specification 0.3 ~ 0.4mm
9