Table of Contents
Advertisement
• •
• •
•
- - - - -
1) Main Power Switch- Turns the main power to the video switcher ON and OFF.
2) IR Sensor Window - For controlling the VS-6 via infrared commands from a hand-held
learning remote (lR codes available for download at www.nilesaudio.com).
3) Component Video Inputs - Six sets of component video (Pb, Pr and
Y) RCA jacks
provide input connections for source components.
4) BuHered Cascade Component Video Outputs - Used to connect to a slave
VS-6 or to a home theater receiver. Asource connected to a Component Video Input cascades
its video signal out to the corresponding buffered cascade video output. These outputs use the
standard Pb, Pr and Ycables with RCA termination.
S) Zoned Component Video Outputs - Six sets of component video (Pb, Pr and
Y)
RCA jacks provide zoned output connections to televisions.
6) Zoned Balanced CAT-S Component Video Outputs - Six female RJ-45 jacks
for connection to Niles passive component video baluns via CAT-5 cable. These outputs correspond
to the zoned component RCA video outputs and can be used simultaneously with them (use a
C5-HOOA or C5-HOOAWM at TV end).
7) Out To Master Connection - Afemale RJ-45 jack provides a connection and
communication with a compatible Niles Network MultiZone Receiver for a seamless distributed
audiolvideo solution.
8) Communication Ports - The six additional RJ-45 Communication Ports are labeled 1-6.
They are used for communications with and control of products such as Niles Network keypads
and the IRG (Infrared Gateway). The communication with these products is done over CAT-5 cable.
9) RS-232 Control Input Connection - Anine-pin 08-9 female jack provides an input
connection for external control devices to operate the VS-6 using RS-232 string codes (codes are
available at the end of manual).
10) IR Control Input Connection - A3.5mm jack provides an input connection so the
VS-6 can be controlled by IR codes from an Infrared Repeater Main System Unit or from a Niles
MultiZone Receiver (IR codes available for download at www.nilesaudio.com).
11) Voltage Switch - Switches the VS-6 for either 11 OV or 230V AC power.
12) IEC Power Receptacle - Two-pin power socket to connect the removable power cord.
13) Set Up Dipswikhes - Used to designate Unit 10, IR/RS-232 or network control ofVS-6.
14) Rack Mount Ears - Two metal rack-mount ears for installation into professional metal rack.
With rack-mount ears installed, the VS-6 is 3U (Units) high.
NILES AUDIO CORPORATION -1-800-BUY-HIFI- 305-238-4373----------
3
Advertisement
Table of Contents
