Table of Contents
Advertisement
User's Guide
Installing Receiver on PL3 LED Luminaires
To install on a PL3 LED Luminaire:
WARNING! Before proceeding, remove power from PL3 LED luminaire.
Step 1. Unpack unit and make sure all parts are present.
Step 2. If antenna is not installed, install antenna.
CAUTION: In next step, do not twist ribbon cable. The RED stripe on ribbon cable should be towards the rear of the
luminaire.
Step 3. A rear of receiver, connect 20-pin ribbon cable (provided with unit) to 20-pin female header connector on
unit.
Step 4. Position unit over luminaire mounting point as shown in Figure 3. Make sure ribbon cable is completely
encased in receiver housing before securing to luminaire. Do not pinch ribbon cable.
PL3 LED
Luminaire
20-Pin Interconnection
Ribbon Cable (See Note B)
Note B: Make sure the red stripe is towards the rear of
the luminaire when connecting ribbon cable to fixture.
Step 5. Install receiver unit by inserting two M4 X 30 mm socket cap head screws (provided with unit) through
holes in receiver housing into luminaire. Hand-tighten screws using a 3 mm Allen Wrench (not provided).
Do not over tighten!
Step 6. Once installation is complete, proceed to
configuration instructions.
6
WIRELESS DMX RECEIVER INSTALLATION
M4 x 30 mm SCHS
Screws (x2)
Figure 3: Wireless DMX Receiver Installation - PL3 LED Luminaires
20-Pin Female
Connector
Wireless DMX Receiver
"WIRELESS DMX RECEIVER OPERATION" on page 7
PL1IRR Remote Control
for
Advertisement
Table of Contents
