Tektronix 4685F16 Instructions

16-mbyte ram simm

16-Mbyte RAM SIMM Installation — (4685F16)

Only proprietary Tektronix RAM SIMMs will operate correctly in Tektronix Color printers.

Static electricity precautions

1995

Leave the printer plugged into its power outlet; this preserves a

ground path for static discharges.

Touch the printer's bare metal frame often to discharge static

electricity from your body.

Handle the circuit board(s) by their edges only.

Do not lay the board(s) on a metal surface.

Make the least possible movements to avoid generating static

electricity.

Avoid wearing wool, nylon or polyester clothing; they generate static

electricity.

Professional, on-site installation is just a phone call away. Productivity is

important to your business success – so when you need it done right – the ﬁrst

time – call Tektronix. Tektronix' on-site installation delivers what you've been

looking for: expert service technicians who provide quality, on-site product

installation. In the United States and Canada, call 1-800-835-6100.

Instructions

Phaser® 350

Table of Contents

Do you have a question about the 4685F16 and is the answer not in the manual?

Page 1: Static Electricity Precautions
Instructions Phaser® 350 16-Mbyte RAM SIMM Installation — (4685F16) Only proprietary Tektronix RAM SIMMs will operate correctly in Tektronix Color printers. Static electricity precautions Leave the printer plugged into its power outlet; this preserves a ground path for static discharges.
Page 2 16-Mbyte RAM SIMM Installation — (4685F16) Installation Power down the printer. Leave the power cord plugged in to provide a ground path for static discharges. Remove the interface cables. Loosen the two rear panel securing screws. Slide out the main board.
Page 3 16-Mbyte RAM SIMM Installation — (4685F16) If a RAM SIMM, such a a 4-Mbyte RAM SIMM, is already installed in the RAM SIMM connector, labeled J20, it must be removed. Metal pawls at each end of the RAM SIMM connector secure the RAM SIMM in the connector.