Radio Operation; Aux Input - TDK iCUBIC Setup Manual

Radio Operation

• Press the function button to select the tuner mode on the unit (or remote control) to select the radio
FM operation.
• Select the desired frequency with the skip/search (up or down) button continuously until you read the
correct frequency or the reception is at its best.
Mono/stereo select
This unit can receive FM mode only.
• When you want to select FM stereo station, press the repeat/mono/st. button.
When you receive a FM stereo station the "
receive FM stereo transmission.
• When you press the repeat/mono/st. button again, the FM stereo indicator will turn off and switch to
mono FM status.
Automatic tuning
• Press the skip/search (up or down) button for a few seconds, then release the button. The tuner will
automatically search the first station of sufficient signal strength.
• Repeat above procedure if you wish to select another station.
Programming preset stations
You can also preset stations of your choice and store up 20 FM stations in its memory. To store your
selected broadcasting stations.
• During the unit in tuner mode, press the skip/search (up or down) button to search the required
station.
• Press the memory button.
• Press the preset/arrow ( or ) button for your desired station number.
• Press the memory button once again to confirm your selection.
• To program more stations into memory, repeat the above steps 1 to 4.
• To change the stored preset stations, repeat the above steps 1 to 4.
Note:
• Storing a new station into a preset location will erase the previously stored station in that location.
• Power off/failure or power cord disconnection will clear the memory of all preset stations.
Perform the stations presetting procedures again to store the stations.
Selecting the preset stations
• Press the preset/arrow (up or down) button to select the desired preset station number.
• The numeric location of that preset station is displayed along with the corresponding frequency.
FM antenna
Make sure the FM wire antenna is unwound and extended to its full length. It may be necessary to vary
the direction of this antenna until you find the position that provides the best reception for your favorite
FM stations.
13
" indicator will appear on the display, you can

AUX Input

The AUX input is located at the rear of the unit. Use a 3.5 mm stereo jack cable to connect audio
equipment through the line in jack.
• To select the AUX input function, repeatedly press the function button on the unit (or remote control)
until the AUX is indicated on the display.
• Press the volume (up or down) button to adjust the sound output level.
EQ Control (on the remote control)
EQ shows the present sound tone.
When you press the EQ button on the remote control, the sound tone changes as below.
Flat Classic
To Set Sleep Function
• If you want to fall asleep to music, press the sleep button on the unit only.
• You may adjust the iPod, AUX or tuner sleep function to play from 90, 60, 45, 30 up to 15 minutes of
music before shutting itself off automatically.
90 60
Mute Setting Space (on the remote control)
• When you press the mute button once on the remote control, the mute and the current audio mode
indicators will flash, the audio output will be temporarily terminated.
Mute on
• Press the mute button again, the volume level and the audio output will return to normal.
Rock Jazz Pop
45 30 15 00
Normal
FM 88.50
MHz
FM 88.50
MHz
14