Charging The Battery - Canon EOS-1DX Instruction Manual

Charging the Battery

It takes approx. 130 min. for LP-E4N and approx. 120 min. for LP-
E4 to fully recharge a completely exhausted battery at 23°C/73°F.
The time required to recharge the battery will vary greatly
depending on the ambient temperature and the battery's
remaining capacity.
The LC-E4N charger cannot charge any battery other than the Battery
Pack LP-E4N/LP-E4.
Depending on the battery's condition, charge may not reach 100%.
30
1
Connect the charger to a power outlet.
Connect the power plug to a power
outlet, and connect the power cord to
the charger.
When no battery is attached, all the
indicator lamps will be off.
2
Remove the protective covers.
As shown in the illustration, detach
the charger's protective cover
(provided) and the battery's protective
cover (provided).
3
Recharge the battery.
Slide the battery into the charger's
slot as shown by the arrow, and make
sure it is securely attached.
You can attach the battery to slot A or B.
The battery will start recharging and
the green status lamp will blink.
When the battery is fully charged, all
three Charge level indicators will light
up (50%/80%/100%).