Fit Speaker To Mounting Fittings In Correct Direction; Tighten From Back Using The Supplied Screws - Pioneer PDP-S40S Operating Instructions Manual

English
2. Fit the speaker to the mounting fittings in the correct direction.
• Be sure not to mount the speaker upside down.
For illustrative purposes,
the table top stand is not
presented here.
Caution
• To avoid any damage to the speaker and/or table top stand from striking against each other, fit the speaker to the mounting
fittings while confirming their locations. As you may easily strike the stand, use the protective wrapping in which the speaker
was wrapped between the speaker and stand.
• When the speaker mounting fittings do not fit the grooves at the rear of the speaker, adjust the speaker mounting fittings
angle.
3. Tighten from back using the supplied screws (three locations).
• Tighten the three screws in order 1, 2, 3 as shown in the diagram.
3
Speaker mounting screw
(M5 x 10 mm)
1
Speaker mounting screw
(M5 x 10 mm)
4
Insert the groove on the
back of the speaker into the
speaker mounting fitting.
When using the table top
stand, do not use these holes.
Speaker mounting screw
(M5 x 10 mm)
The bottom side of the speaker has a round corner when
viewed from the front side of the plasma television.
The screw hole at the bottom surface of the
speaker mounting fitting is used when the
plasma television is installed on the wall. It
is not used when installed with the stand.
2
If after attaching the speaker its position
needs to be adjusted horizontally or
vertically, first loosen the speaker mounting
screws, reposition and then tighten the
screws again at the appropriate position.
Protective
wrapping
Front side of
the speaker
The upper side of the speaker
does not have a round corner.
CAUTION
If you want to move the plasma television,
make sure that you remove the speaker
first.
In addition, do not move the display holding
on to the mounting fittings. This can result
in injury or damage to the unit.
NOTE: