Operation - Hydro-Drive Models - Murray Parklander2690997 Operator's Manual

Mowing and Bagging Tips
1. For a lawn to look better, check the cutting level of
the mower housing. See "How To Level The Mower
Housing" in the Maintenance section.
2. For the mower housing to cut level, make sure the tires
have the correct amount of air pressure.
3. Every time you use the unit, check the blade. If the
blade is bent or damaged, immediately replace the
blade. Also, make sure the nut for the blade is tight.
4. Keep the blade(s) sharpened. Worn blades will cause
the ends of the grass to turn brown.
5. Do not cut or bag grass that is wet. Wet grass will not
discharge correctly. Let the grass dry before cutting.
6. Use the left side of the mower housing to trim near an
object.
7. Discharge the cut grass onto the mowed area. The
result is a more even discharge of cut grass.
8. When you mow large areas, start by turning to the right
so that the cut grass will dis charge away from shrubs,
fences, driveways, etc. After one or two rounds, mow in
the op posite direction making left turns until fin ished.
9. If the grass is very high, cut two times to de crease the
load on the engine. First cut with the mower housing in
the highest position and then lower the mower housing
for the second cut.
10. For better engine performance and an even discharge
of the cut grass, always operate the engine with the
throttle in FAST position.
11. When you use a bagger, operate the engine with the
throttle in FAST position and the shift lever in first or
second gear.
12. For better cutting performance and a quality cut, mow
with the shift lever in one of the slower speeds.
13. After each use, clean the bottom and top of the mower
housing for better performance. Also, a clean mower
housing will help pre vent a fire.

Operation - Hydro-Drive Models

Using Controls
How To Use The Throttle Control (Figure 6)
Use the throttle control (G) to increase or de crease the
speed of the engine.
1. The FAST position is marked with a detent. For normal
operation and when using a grass bagger, move the
throttle control to the FAST position. For maximum
charging of the battery and for a cooler running engine,
oper ate the engine in the FAST position.
2. The engine governor is set at the factory for maximum
performance. Do not adjust the governor to increase
the speed of the en gine.
How To Use The Blade Rotation Control (Figure 6)
Use the blade rotation control (A) to engage the blade(s).
1. Before you start the engine, make sure the blade
rotation control (A) is in the DISEN GAGE position.
2. Move the blade rotation control (A) to the ENGAGE
position to rotate the blade(s).
NOTE: If the engine stops when you en gage the
blade(s), the seat switch is not activated. Make sure
you sit in the middle of the seat.
3. Move the blade rotation control (A) to the DISENGAGE
position to stop the blade(s). Before you leave the
operator's position, make sure the blade(s) has stopped
rotating.
4. Before you ride the unit across a sidewalk or a road,
move the blade rotation control (A) to the DISENGAGE
position.
WARNING: Always keep your hands and feet away
from the blade, deflector opening, and the mower
housing when the engine runs.
How To Use The Speed Control Pedal (Figure 6)
The drive system uses a Hydrostatic Automatic Drive
transmission. The Hydrostatic trans mission is very easy to
operate. This type of drive system does not require a shift
lever or a clutch pedal.
The speed and direction of travel is controlled by a single
speed control pedal (D) operated with your right foot. Do
not use the left brake pedal in normal operation. Only use the
left brake pedal to quickly stop in an emergency.
Operation
21