ENGLISH (Original instructions) SPECIFICATIONS Model BPB180 Round workpiece 120 mm dia. Max. cutting capacity Rectangular workpiece 120 mm x 120 mm Blade speed 1.4 - 2.7 m/s Length 1,140 mm Blade size Width 13 mm Thickness 0.5 mm Overall dimensions (L x W x H)
Do not use any Makita Corporation responsible adapter plugs with earthed (grounded) power manufacturer declare that the following Makita tools. Unmodified plugs and matching outlets will machine(s): reduce risk of electric shock. Designation of Machine:...
Page 4
Use of the power Never use the cutting oil as a cutting lubricant. tool for operations different from those intended Use only Makita cutting wax. could result in a hazardous situation. Do not wear gloves during operation.
Never recharge a fully charged battery WARNING: cartridge. DO NOT let comfort or familiarity with product Overcharging shortens the battery service life. (gained from repeated use) replace strict adherence Charge the battery cartridge with room to safety rules for the subject product. MISUSE or temperature at 10 ゚...
CAUTION: NOTE: Before inserting the battery cartridge into the tool, Use a dry cloth to wipe the dirt off the lens of lamp. • • always check to see that the switch trigger actuates Be careful not to scratch the lens of lamp, or it may properly and returns to the "OFF"...
OPERATION 1. Upper holder 2. Lower holder It is important to keep at least two teeth in the cut. 3. Wheel 4. Press 006193 Hold the blade in place and turn the blade-tightening lever counterclockwise until it hits against the protrusion on the frame.
Cutting lubricant Replacing carbon brushes When cutting metals, use Makita cutting wax as a cutting lubricant. To apply the cutting wax to the blade teeth, 1. Limit mark start the tool and cut in to the cutting wax as shown in the figure after removing a cap of the cutting wax.
Page 12
Makita Corporation Anjo, Aichi, Japan www.makita.com 884663A224...