Epson Stylus Pro 7600 Printer Manual page 51

1-36 | Setting Up the Printer
Note
If you're connecting with
a parallel cable or
Ethernet card, do not turn
on your printer when you
see a window telling you
to do so. Instead, wait
until the Stop Searching
button appears. Then
click the button and go to
step 7.
When installation is
complete, the port
setting defaults to LPT1
(parallel port). If you're
using an Ethernet card,
you'll have to reconfigure
the port setting. See your
electronic Reference
Guide for details.
6. If you're connecting with a parallel cable or network interface card, see
the note at left. Otherwise, follow the instructions below for your
operating system.
Windows 95 or NT: Turn on your printer and go to step 7.
Windows 98, Me, or 2000: When you see a window asking you to turn
on your printer, press the P
Windows XP:
When you see a window asking you to turn on your printer, press
•
the P
Power
If you see a message that your printer is not connected properly,
•
ignore it (do not click
window to the side.
Wait until you see the Found New Hardware Wizard for the Stylus
•
Pro 7600 or 9600. This may take a minute or two.
Once the Found New Hardware Wizard appears, click
•
a list or specific location
Locate the
• Drivers\Win2K_XP
shown below. Then click
7. When you see a message informing you that installation is complete,
click or
OK Finish
8. If any screens remain open or continue to open, close them to exit.
1-36
button. Then go to step 7.
Power
button.
or
Retry Cancel
, then click
folder on your CD-ROM drive, as
.
Next
. If asked to do so, restart your computer.
). If necessary, drag the
Install from
.
Next