Table of Contents
Advertisement
FASTENING SCROLL SAW
TO SUPPORTING SURFACE
This scroll saw MUST be securely fastened to a stand or
workbench using the three holes, two of which are
shown at (A) Fig. 4. The third hole is at the rear of the
machine.
An alternate method of securing the scroll saw to a sup-
porting surface is to fasten the scroll saw to a mounting
board. Then securely clamp the mounting board to a
stand or workbench using two or more C-clamps.
NOTE: For proper stability, the holes in the mounting
board must be countersunk at the bottom so that the
fastener heads are flush with the bottom surface of the
mounting board.
OPERATING CONTROLS AND ADJUSTMENTS
ON-OFF AND VARIABLE
SPEED SWITCH
The on-off switch (A) Fig. 5, and variable speed control
(B) is located on the right side of the scroll saw base. To
turn the saw "ON," move the switch (A) up to the "ON"
position. To turn the saw "OFF", move the switch (A)
down to the "OFF" position.
The scroll saw is equipped with a variable speed control
(B) Fig. 5. The variable speed range is 600 to 1650
strokes per minute. When the variable speed knob (B)
Fig. 5, is rotated all the way to the left (counterclockwise)
the speed will be 600 strokes per minute. To increase the
speed, rotate knob (B) to the right (clockwise) until the
desired speed is obtained. When the knob (B) is rotated
all the way to the right (clockwise) the speed will be 1650
strokes per minute.
LOCKING ON-OFF SWITCH
IN THE "OFF" POSITION
IMPORTANT: When the machine is not in use, the switch
should be locked in the OFF position to prevent
unauthorized use. This can be done by grasping the
switch toggle (B) and pulling it out of the switch, as
shown in Fig. 6. With the switch toggle (B) removed, the
switch will not operate. However, should the switch
toggle be removed while the saw is running, the switch
can be turned "OFF" once, but cannot be restarted
without inserting the switch toggle (B).
B
9
A
Fig. 4
A
Fig. 5
B
Fig. 6
Hide quick links:
Advertisement
Table of Contents
