Factory Setting; How To Turn On The Factory Settings; What Is The Factory Settings - Panasonic HDC-SD40P Service Manual

9 Factory Setting

9.1.

How To Turn On The Factory Settings?

(CAUTION)
Performing the factory settings, the built-in memory is initialized and all of recorded data are deleted.
(SD memory card is not initialized by the factory settings.)
1. Set the mode switch "Recording" mode.
2. Turn the power on, and then while keep pressing the "Zoom lever" to W side, "Intelligent auto/Manual" button and "Menu" but-
ton for more than 3 seconds until the top screen of the Service Mode Menu being displayed.
3. Under the condition of the Item No. "1" is yellow high lighted , then press "ENTER" button.
4. By pressing the "[UP] or [DOWN] of cursor" button and display a highlight in a "YES" item, then press the "ENTER" button.
5. After few seconds "END" is displayed on LCD monitor. Cutting of battery connection or AC power supply connection as a
completion of the "FACTORY SETTINGS".
NOTE:
Do not using service mode except above table of Service mode menu.
End method of the top screen of the service mode menu.
Push the [ MENU ] button to end the service mode, and then POWER OFF.
9.2.

What Is The Factory Settings?

The factory settings clean up and/or refresh the following settings.
1. Physical formatting of the built-in memory. (All user recorded data are deleted)
2. MENU, MODE, ADJUSTMENT VALUE.
3. Reset the folder number and file number of still pictures.
(Setting the folder number is 100, and file number is 0.)
4. Clear the mechanism lock information.
5. Clear the service mode information contents.
6. Initialize the VIERA Link Physical Address.
The setting position of factory settings:
Name
Mode switch
Setting position
Recording mode
24