Table of Contents
Advertisement
26
Placing of receiver
Placing of control box
MASTER LINK
INSTALLATION TIPS
The receiver must be placed so that nothing prevents it from receiving the
signals from a Bang & Olufsen remote control.
When deciding on the position of the receiver, remember that it should
not be possible to activate more than one receiver at a time using a
remote control terminal.
The diagram shows that receiver 3 is placed appropriately, whereas
receiver 1 can be activated from room 2. Receiver 1 should be placed as
receiver 2 instead.
The receiver should not be placed in direct sunlight or direct artificial
light ( e.g. spotlight) or near objects producing electric noise (e.g.
dimmers) as this reduces the sensitivity of the receiver (shorter range).
If the receiver is placed outdoors, please note that it does not function at
temperatures above 55ºC or below 0ºC. If higher or lower temperatures
may occur, it should be possible to switch it off by means of a switch.
Otherwise it can block the operation of the whole system.
It might be a good idea to place the receiver next to a door so that it is
easy for the person entering or leaving the room to operate it.
It might also be an advantage to place the receiver close to the telephone
so that the speakers can easily be muted by the person talking on the
phone.
The control box need not be placed in the same room as the receiver, but
may be placed in the attic, for example. Please, note that temperatures
may not be above 55ºC or below 0ºC.
Hide quick links:
Advertisement
Table of Contents
