Troubleshooting - Jensen HD5313 Installation And Operation Manual

Troubleshooting

Problem Cause
Does not operate No power to yellow wire;
(display does not no power to red wire
light)
Fuse blown
Front panel not installed
properly
No power to unit Fuse blown
Not all speakers Incorrect splices or con-
operate nections
Speaker wires shorting to
chassis ground or to each
other
Blows fuses Power wire shorting to
ground
Speaker wires shorting to
ground
Incorrect fuse/fuse too
small
CD skips too much Receiver mount is not
solid or backstrap is not
secure
Installation angle more
than 30%
ERROR 1 Mechanism error
No File No supported files found
on disc/card
Disc error Disc dirty, scratched,
upside down
Corrective Action
Check connection with test light;
check vehicle fuse with test light
Replace fuse
Reinstall front panel
Check/replace fuse
Check all splices and connec-
tions
Check splices, insulate all bare
wires
Make sure wire is not pinched
Make sure wire is not pinched
Install fuse of correct rating
Check mounting and backstrap,
tighten if needed
Adjust angle to less than 30%
Press reset button
Insert different disc card with
appropriate file type
Replace with clean, properly
installed disc
16
HD5313