Care And Maintenance; Troubleshooting - Jensen JCV2015BT Installation And Operation Manual

CARE AND MAINTENANCE


Keep the product dry. If it does get wet, wipe it dry immediately. Liquids might contain
minerals that can corrode the electronic circuits.

Keep the product away from dust and dirt, which can cause premature wear of parts.

Handle the product gently and carefully. Dropping it can damage circuit boards and cases,
and can cause the product to work improperly.

Wipe the product with a dampened cloth occasionally to keep it looking new. Do not use
harsh chemicals, cleaning solvents, or strong detergents to clean the product.

Use and store the product only in normal temperature environments. High temperature
can shorten the life of electronic devices, damage batteries, and distort or melt plastic
parts.
Ignition
The most common source of noise in reception is the ignition system. This is a result of the radio
being placed close to the ignition system (engine). This type of noise can be easily detected
because it will vary in intensity of pitch with the speed of the engine.
Usually, the ignition noise can be suppressed considerably by using a radio suppression type
high voltage ignition wire and suppressor resistor in the ignition system. (Most vessels employ
this wire and resistor but it may be necessary to check them for correct operation.) Another
method of suppression is the use of additional noise suppressors. These can be obtained from
most CB/A radio or electronic supply shops.
Interference
Radio reception in a moving environment is very different from reception in a stationary
environment (home). It is very important to understand the difference.
AM reception will deteriorate when passing under a bridge or when passing under high voltage
lines. Although AM is subject to environmental noise, it has the ability to receive at great
distance. This is because broadcasting signals follow the curvature of the earth and are
reflected back by the upper atmosphere.

TROUBLESHOOTING

Symptom Cause
The vehicle's accessory
No power
switch is not on
Fuse is blown
Disc cannot be loaded or Presence of CD disc inside
ejected the player
Inserting the disc in upside
down
Compact disc is extremely
dirty or disc is defective
Condensation
No sound Volume too slow
Wiring is not properly
connected
The operation keys do Control panel is not
not work properly installed
Built-in microcomputer is
not operating properly due
to noise
Sound skips Installation angle is more
than 30 degrees
Disc is dirty or defective
Cannot tune to radio Antenna cable is not
station, auto-seek does connected
not work
Signals are too weak.
ERROR-01 on LCD Database or decoder error
ERROR-02 on LCD Disc not supported
ERROR-03 on LCD No songs on device
ERROR-04 on LCD Abnormal current to USB
device
ERROR-04 on LCD iPod/iPhone is not verified
18
JCV2015BT
Solution
If the power supply is properly
connected to the vehicle's
accessory terminal, switch the
ignition key to "ACC".
Replace the fuse.
Remove the disc in the player
and insert the new one.
Insert the compact disc with the
label facing upward.
Clean the disc or try to play a new
one.
Leave the player off for an hour or
so, then try again.
Adjust volume to audible level.
Check wiring connections.
Reinstall control panel.
Press the RESET button.
Adjust the installation angle to
less than 30 degrees.
Clean the disc and try to play
again or use a new disc.
Insert the antenna cable firmly.
Select a station manually.
Change to another mode.
Remove disc and insert
supported CDDA or CD-ROM
disc.
Remove device and add songs.
Change mode or unplug and
reconnect USB device.
Unplug and reconnect
iPod/iPhone.