MSI ATX BX2 User Manual page 77

Chassis Intrusion Detect
Set this option to Enabled, Reset, or Disabled the chassis intrusion
detector. During Enabled, any intrusion on the system chassis will be
recorded. The next time you turn on the system, it will show a warning
message. To be able to clear those warning, choose Reset. After clearing
the message it will go back to Enabled.
CPU Speed
Check you processor and set this function accordingly. If you set
this to Manual, you can set the CPU Ratio and CPU Frequency accordingly.
CPU Frequenies are: 66, 68, 75, 83 and 100, 103, 112, 133. Though 68, 75, 83,
103, 112, and 133 frequencies are available, it is adviced that you use these
only for testing since this might cause instability as the CPU is not de-
signed for these frequencies. CPU ratio are: 3, 3.5, 4, 4.5, 5, 5.5, 6, 6.5, 7, 7.5,
or 8.
Note: if you set the CPU Ratio and CPU Frequency to be too high, and the
system will not turn on. Then restart the system, press "F10" until bootup.
This will set the default setting.
Chassis/Power/CPU Fan RPM
During Enabled, this will monitor the RPM of your CPU/Chassis/
Power fan.
System Temperature/CPU Temperature
This will show the System and CPU temperature.
CPU Critical Temp
This option is for setting the critical temperature level for the proces-
sor. when the processor reach the temperature you set. This will reduce the
load on the processor.
Shutdown Temp
This option is for setting the Shutdown temperature level for the
processor. when the processor reach the temperature you set. This will
shutdown the system. This function only works with Windows
ing system.
3-29
®
®
95 operat-