Indicators And Controls; Crossover (X-Over); Power/Protect Light - Jensen XA4200 Installation And Operation Manual

®

Indicators and Controls

Crossover (X-OVER)

Adjust the crossover to accommodate your
chosen installation method.
• LPF–(low pass filter) Select
this filter when the amplifier will
LPF
be driving woofers or
FULL
subwoofers.
HPF
X-OVER
• FULL–Crossover is not active,
FRONT
amplifier is in "full range"
REAR
mode.
LPF
FULL
• HPF–(high pass filter) Select
HPF
this filter when the amplifier will
X-OVER
be driving full range/separate
speakers, and you want to limit
the "bass" going to these
speakers.
Power / Protect Light
POWER/
A dual status LED indicator illuminates
PROTECT
red or green to indicate the status of
the amplifier.
Green – Power applied, ON
Red – Protection circuit activated, STANDBY
10
5910 XA4CH_E.p65
LPF
FULL BASS L-CH X
HPF
FRONT
REAR
LPF
0dB 12dB 40Hz
FULL
L-CH X
BASS
HPF
0dB 12dB 40Hz
10
R-CH X LEVEL
POWER/
PROTECT
2CH
400Hz 40Hz 400Hz MIN MAX
3CH
R-CH X
LEVEL
4CH
400Hz 40Hz 400Hz MIN MAX
Tri-mode/Three channel operation
An amplifier is usually configured for tri-mode
operation when you want to use one amplifier to
drive a pair of front speakers and subwoofer(s).
In other words, when you want drive a complete
system with one amp. Your Jensen amplifier is
capable of tri-mode operation.
Important
Tri-mode operation requires using "passive
crossovers". These crossovers are available at
your local retailer or install shop. Failure to
install these filters may damage your amplifier
and/or your speakers.
01/23/01, 12:24 PM
XA4200, XA4300