Tighten screws 1 on left and
right.
Beam-throw basic setting
Slacken screws 1 on left and
right.
Tilt the headlight slightly
about its horizontal axis until
arrowhead 2 is pointing toward
marker 3.
Tighten screws 1 on left and
right.
Seat
Removing seat
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Use the ignition key to turn
seat lock 1 counter-clockwise
and hold it in this position.
Lift seat 2 at the front and re-
lease the key.
Remove the seat and set it
down on the rubber buffers.
Installing seat
Engage the seat in holders 3.
4
55
z