Table of Contents
Advertisement
6. Remove the insulation piece with the tongue on top of the other insulation piece, and
reinstall the small rectangular piece that was removed in step 4 above
7. Reinstall the front cover and hang the oil burner on the bracket, do not install nuts yet
8. Install the glass and cover with gasket installed around edge of glass
CAUTION: THE GLASS WILL BREAK IF YOU WRENCH TIGHTEN THE SCREWS,
USE A NUT DRIVER OR SIMILAR DEVICE TO ENSURE NO GLASS BREAKAGE
9. Switch the selector switch to Coal and make sure fire brick are in place around fire grate,
remove front door to gain access for lighting the boiler.
Please call us at 570-752-1811 if there are any questions, if your need for help is
after normal business hours please call 570-815-9732 and speak with Matt
DANGER - Risk of Fire or Explosion - Do not burn garbage, gasoline, drain oil or other flammable liquids.
CAUTION – HOT SURFACES – KEEP CHILDREN AWAY – DO NOT TOUCH APPLIANCE DURING OPERATION
DO NOT CONNECT THIS UNIT TO A CHIMNEY SERVING ANOTHER APPLIANCE
WARNING –
RISK OF FIRE – DO NOT OPERATE WITH A FLUE DRAFT EXCEEDING -.07" wc,
OPERATING AT A DRAFT ABOVE -.07" wc CAN CAUSE UNIT TO BURN BACK INTO THE HOPPER
DO NOT OPERATE WITH ASH REMOVAL DOOR OPEN
DO NOT STORE FUEL OR OTHER COMBUSTIBLE MATERIAL WITHIN MARKED INSTALLATION CLEARANCES
CAUTION – BURN RICE OR BUCKWHEAT SIZED ANTHRACITE COAL ONLY
PLEASE SAVE THESE INSTRUCTIONS
Photo on left
shows boiler
during UL
testing with
glass in place
and oil gun on
the mount
Advertisement
Table of Contents
