Adjusting The Carburetor (Only For Not Eu-Countries) - Makita DCS430 Instruction Manual

Adjusting the carburetor
(only for not EU-countries)
2
1
E
Carburetor adjustment is necessary for optimum engine
performance, for safer and more economical operation. The
engine should be warm, the air fi lter clean, and the chain
properly tensioned. Have carburetor adjustment done by
an authorised MAKITA service centre.
The carburetor is factory-adjusted for the air pressure at sea
level. At other elevations or under other conditions of weather,
temperature, or humidity, or when breaking in a new engine, it may
be necessary to make slight adjustments to the carburetor.
You will need a tachometer (1, part No. 950 233 210) for
optimum adjustment.
Do not go below the specifi ed setting of the main nozzle
(H). Doing so may cause engine damage due to overheating
and insuffi cient lubrication!
Use the supplied carburetor screwdriver (2) for carburetor adju-
stment. It has a moulded-on projection that aids in adjusting.
Before undertaking the adjustment, run the engine for 3-5 mi-
nutes to warm it up, but not at high speed!
For proper adjustment, proceed as follows:
1. Basic setting (engine off)
Start engine and warm up.
2. Set idle
3. Check acceleration
4. Check top speed
5. Check idle speed
Repeat steps 2-5 until you get the right idle speed, good
acceleration and maximum permissible
16
1. Basic setting
Carefully turn the adjusting screws for the main nozzle (H)
and idle nozzle (L) clockwise until you feel a stop.
Turn adjusting screws (H) 1
2. Set idle
Set the idle speed per the technical specifi cations.
Turning the adjusting screw (S) in (clockwise) increases the
idle speed. Turning it out (counter-clockwise) lowers the idle
speed. In no case should the chain move.
3. Check acceleration
When the throttle is pressed, the engine should go smoothly
from idle to high speed. If this is too slow, turn the adjusting
screw (L) in small (max. 1/8 turns) increments counter-clo-
ckwise.
4. Check top speed
The basic setting H=1 1 /
of about 13,500 rpm.
For higher speed (electronically limited ), turn the adjusting
screw (H) a maximum 1/4 turn clockwise.The top speed
in the governor can be clearly heard from the ignition mis-
ses.
Note: Since there is an electronic speed governor (limiter)
at 13,500 rpm that cuts off the ignition current, the top speed
cannot be read from the tachometer.
Important: To prevent engine damage, never go below
setting (H) 1 1 / turns.
4
5. Check idle speed
Check the idle speed after setting the top speed (the chain
must not move).
Repeat the adjustment procedure starting at Step 2, until the
engine runs with the correct idle speed, good acceleration,
and top speed.
1 / and (L) 1 1 / counter-clockwise.
2 2
and L=1 1 / gives a maximum speed
2 2