Table of Contents
Advertisement
4.
Pass the remote control cable through the supplied wire grommet
and fit the grommet into the maintenance cover knockout.
5.
Plug the remote control cable into the 6-pin connector.
6.
Install the maintenance cover and tighten the cover screw.
REMOTE CONTROL CABLE
REMOTE CONTROL CABLE
REMOTE CONTROL BOX
7.
To avoid accidentally unplugging the remote control cable, secure
the cable to the generator frame with a cable tie as shown.
Never operate the generator without the maintenance cover in place,
as poor engine and generator performance will result.
When the remote control is not being used, replace the plug on the
connector.
MAINTENANCE COVER
CABLE TIE
PLUG
GROMMET
63
Hide quick links:
Advertisement
Table of Contents
