Advertisement
5. CLEANING THE REFLECTOR
s Disconnect the spotlight from the mains and remove the lamp casing as described in chapter
2.1.
s Remove the color frame (chapter 4), the protective mesh and lens (chapter 3.1), so that the
reflector is easily accessible.
s Cleaning the reflector: Use oil-free compressed air or a soft, lint-free cotton cloth. Tenacious
stains can be removed by adding some mild soap water, however, don’t forget to remove all
soap water remnants as well!
s Remount the spotlight (see chapters 2.1 and 3.2).
+
Never clean the reflector with commercial window cleaners, as the chemical
substances contained in these agents can damage the reflective coating!
+
Don’t use paper towels or other material with a rough surface to wipe the reflector
clean, so as to avoid scratches damaging the reflector surface.
6. SUSPENDED INSTALLATION
Use the mounting bracket
with a diameter of approx. 12 mm to fasten the spotlight. Your UP1000 must be secured with an
additional safety steel cable
the spotlight has been adjusted, it must be secured in place with the locking screw
7. SPECIFICATIONS
Power
Max. room temperature
Max. temperature of exterior
surfaces
Dimensions (Height * Diameter)
Weight
BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these efforts, modifications may be
made from time to time to existing products without further notice. Specifications and appearance may differ from those listed or shown.
6
ULTRAPAR UP1000
to attach your spotlight to a stand or truss. Always use steel screws
. Use the steel cable fixed to the spotlight casing (eyelet
575 W max. (220 V / 240 V)
T a = 45°C
T max = 175°C
approx. 11 3/4" (300 mm) * 9 1/4" (237 mm)
approx. 3.2 kg
7. SPECIFICATIONS
). Once
.
Advertisement
