Advertisement
3.1
Dismounting the lens
+
The lens gets very hot during operation of the spotlight, so let it cool down sufficiently
before you attempt to dismount it!
s Disconnect the spotlight from the mains and wait until it has cooled down.
s Place the spotlight on a flat and stable surface. Never mount or dismount the lens, while the
spotlight is fixed to a truss or stand.
s Remove the protective mesh
s Directly in front of the lens, you will find a movable metal clamp
Turn the lens ring, until the metal clamp is located on the top side of the spotlight (directly below
the locking bracket
s Tilt the front side of the spotlight forward by at least 45°.
s Push the movable metal clamp upward to dismount and pull out the lens
3.2
Mounting the lens
s Tilt the spotlight forward and turn the lens ring, until the movable metal clamp
the top side of the spotlight (directly below the locking bracket
s Insert the lens with its rounded side towards the rear. The lower edge of the lens must be
located behind the projecting elements
+
Inserting the lens with its rounded side towards the front does not effect the optics of
your ULTRAPAR, but will make it more difficult to dismount the lens later on.
s Press the upper edge of the lens slightly towards the rear, until it locks in behind the metal clamp
.
s Installation of the protective mesh
and place it directly in front of the lens ring
ULTRAPAR for the “feet” of the protective mesh. The two spring shackles must be located
directly below the locking bracket
4. COLOR FRAME
The color frame
install the color frame:
s Detach the locking bracket
open the bracket and tilt it towards the rear.
s Insert the color frame into the frame holders
on three sides) on the front side of the ULTRAPAR.
s Push the locking bracket
ULTRAPAR UP1000
: press its two spring shackles, then pull out the mesh.
).
: Press the two spring shackles of the protective mesh
.
is used to hold the color foils. Please observe the following instructions to
on the top side of the spotlight, by pushing it to the side. Then,
to the side and move it down until it locks in.
4. COLOR FRAME
of the lens ring.
. There are two slots in the die-cast casing of your
and
, i.e. the outer guiding rail (with stops
attached to the lens ring.
.
is located on
).
5
Advertisement
