Advertisement
BDTF1609-IN
Fig. 1
9
8
7
6
10
1. Oscillation Knob
2. Motor Asembly
3. Rear Guard
4. Guard Retaining Nut
5. Large Blade
6. Small Blade
Fig. 2
BDTF1609-IN
9
8
7
6
10
5
4
3
2
11
7. Blade Retaining Nut
8. Guard Loop
9. Front Guard
10. Guard Locking Screw/Nut
11. Base
Fig. 3
4
5
3
2
11
ENGLISH
PLEASE READ AND SAVE THESE
IMPORTANT INSTRUCTIONS
1. Read all instructions before using this
1
appliance.
2. To avoid fire or shock hazard, plug the
appliance directly into an appropriate
electrical outlet.
3. Keep the power cord out of heavy
traffic areas. To avoid fire hazard,
NEVER put the power cord under
rugs, near heat registers, radiators,
stoves, or heaters.
4. To protect against electrical hazards, DO
NOT immerse the appliance in water or
other liquids. Do not use near water.
5. NEVER drop or insert any objects into
the openings of the unit.
6. Do not operate any appliance with a
damaged power cord or plug. If the motor
fails to operate or the unit has been
dropped or damaged in any manner,
return appliance to manufacturer for
examination and/or repair.
7. DO NOT use outdoors.
8. NEVER place on a soft surface such
as a bed or sofa as this could cause
the unit to tip over and block the air
inlet or outlet grills.
9. DO NOT place anything on top of unit.
10.WARNING: To reduce the risk of fire or
electric shock, DO NOT use this
appliance with any solid-state speed
control device.
11. CAUTION: In order to avoid a hazard
due to inadvertent resetting of the
thermal cutout, this appliance must not
be supplied through an external
switching device, such as a timer, or
connected to a circuit that is regularly
switched on and off by the utility.
12.This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
HINDI
1
lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for
their safety. Children should be
supervised to ensure that they do not
play with the appliance.
13.This product is not desgned or
intended to be used with an extension
cord.
ASSEMBLY INSTRUCTIONS
1. Remove the blade retaining nut
(turning clockwise) while holding motor
shaft. Then remove the guard retaining
nut (turning counter-clockwise). Take
off the motor shaft sleeve protector
and discard.
2. Set the rear guard in the proper
position (carry handle topmost) on the
motor assembly. Make sure that the
pins on the rear guard align with the
pins on the motor assembly. Then
screw on the guard retaining nut
(turning clockwise) until tight.
3. Install the large blade onto shaft of the
motor assembly. Then install the small
blade. The flat area of the "D" on the
blade should align with the flat area
of the "D" on the motor shaft. Screw
on the blade retaining nut (turning
counter-clockwise) until tight.
4. Open the guard locking screw/nut.
Place the guard loop on the rear guard
with the guard locking screw/nut at the
bottom. Assemble the front guard on
guard loop until all sides snap. Rotate
the front guard until the Bionaire logo
is horizontal.
5. Secure both guards firmly by fitting
and tightening the guard locking
screw/nut.
6. Remove the plastic screw from the
base (turning counter-clockwise). Then
affix motor assembly to base hole until
snapped. Tighten screw to the base.
Advertisement
