Jenn-Air M418 Use And Care Manual page 29

Cleaning the Temperature Probe
Remove the temperature probe from the receptacle. Wipe food or liquid from the
probe with a damp cloth. Dry completely after use and washing.
DO NOT clean temperature probe in the dishwasher. Probe is sturdy, but care should
be taken in handling. Do not twist or bend; avoid dropping temperature probe.
Cleaning the Oven Rack
Wash the oven rack with a mild soap and a soft or nylon scrub brush. Be sure
to dry completely after washing. Do not clean in a self-cleaning oven.
Cleaning the Vent Hood Exterior (Model M438
only)
The exterior surfaces of the hood shbuld be cleaned often using a solution of mild
soap and warm water and a soft sponge, cloth or paper towel. A chrome cleaner
or polish may also be used to clean chrome, metal and aluminum surfaces.
DO NOT USE oven cleaners, steel wool, abrasive cleaning pads, or abrasive cleaners
as they can scratch or dull surfaces.
Cleaning the Exhaust Filter (Model M438 only)
The aluminum mesh exhaust filter should be removed and cleaned frequently, at
least once a month. Disconnect power to the oven at the circuit breaker panel or
by unplugging.
1. Remove grease filter, grasp the "finger hold" on
the filter and slide to the rear. Then pull filter
downward and to the front. The filter will drop L
out.
2. Soak filter in a sink or bucket filled with hot
water and detergent. DO NOT use ammonia or
clean in an automatic dishwasher. Ammonia and
dishwasher detergent darken aluminum.
3. Agitate and scrub filter to remove embedded
dirt and grease.
4. Rinse thoroughly and shake to dry.
5. To replace grease filter, slide the filter in the frame slot on the back of the opening.
Pull filter upward and to the front to lock into place.
Never operate your hood without the filters in place. In situations where flaming
might occur on surfaces below the hood, the filters will retard the entry of flames
into the unit,
NOTE: Filters should be cleaned at least once a month.
31