Tool Specifications; Intended Use; Noise/Vibration Information; Operating Controls - Bosch GDA 280 E Instruction Manual

Tool Specifications

Delta Sander
Order number
Rated power input
Power output
No-load speed
No-load oscillations
Sanding plate size
(corner to corner)
Weight (without access.) Approx. 1.1 kg
Protection class

Noise/vibration information

Measured values
EN 50 144.
Typically the A-weighted sound pressure level of
the tool is 80 dB (A). The noise level when work-
ing can exceed 85 dB (A). Wear ear protection!
The typical weighted acceleration is 3 m/s

Operating Controls

1 Vacuum hose*
2 Vacuum connection
3 Thumbwheel for oscillation rate
4 On/Off switch
5 Gripping surface
6 SDS slider
7 Ventilation slots
8 Sanding plate
9 Sanding sheet (standard)*
10 Louver sanding attachment*
11 Sanding sheet for sanding tongue*
12 Velcro material for sanding tongue*
13 Sanding tongue (flat)*
14 Sanding tongue (oval)*
*Accessory
Not all of the accessories illustrated or described are
included as standard delivery.
10
GDA 280 E
0 601 294 7..
280 W
112 W
6 500 - 9 500 min
13 000 - 19 000 min
94 mm
/ II
determined according
GB

Intended Use

The machine is intended for sanding and polish-
ing of wood, plastic and metal materials as well
as for painted surfaces.
As a result of its handiness and extensive acces-
sories, the machine can be used for various pur-
-1
poses and is especially suitable for working in
-1
corners, edges and small surfaces as well as for
hard-to-reach places.
to
2
.
safety instructions in the enclosed booklet
must be followed. Before using for the first
time, ask for a practical demonstration.
The machine must be used only for dry grinding.
Always direct the cable to the rear away from
the machine.
Connect machines that are used in the open
via a residual current circuit breaker with a
triggering current of 30 mA maximum. Use
only extension cables that are intended for
outdoor use and are protected against splash
water.
When grinding metal, flying sparks are pro-
duced. Take care that no persons are endan-
gered. Because of the danger of fire, no com-
bustible materials should be located in the
vicinity (spark flight zone).
Bosch can assure flawless functioning of the
machine only when original accessories are
used.
For your safety
Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained therein are strictly
followed. In addition, the general
If the cable is damaged or cut
through while working, do not touch
the cable but immediately pull the
mains plug. Never use the machine
with a damaged cable.
The dust that is produced while
working is detrimental to health.
Use dust extraction and wear a
dust mask.
Do not work with materials contain-
ing asbestos.