Adjustment
4
Solenoid bracket
4.
Solenoid bracket on -900/56
01
8
Requirement
When the tip of trip 1 is aligned with control pin 2 and the engaging lever has been
operated, there must be a clearance of roughly 0.5 mm between the left inside of control
cam 7 and control pin 6.
0.5 mm
Turn balance wheel until tip of trip 1 is aligned with control pin 2.
Operate engaging lever 3.
Loosen both screws 4.
Adjust position of solenoid bracket 5 according to the requirement
In this position, tighten screws 4.
Check this adjustment according to the requirement.
Turn balance wheel opposite feeding direction until control pin 6 is retained.
7
1
2
6
2
4
5
7
3