Service Adjustment Procedures - Mitsubishi Electric 55624R(S)-MF Service Manual

Vent plug
Indicator
Blue
White
Charging Good
condition
necessary

SERVICE ADJUSTMENT PROCEDURES

BATTERY INSPECTION
BATTERY VISUAL INSPECTION (1)
The battery contains a visual test indicator which gives blue
signal when an adequate charge level exists, and white signal
when charging is required.
BATTERY VISUAL INSPECTION (2)
Make sure ignition switch is in Off position and all battery feed
accessories are Off.
1. Disconnect ground cable from battery before disconnecting
2. Remove battery from vehicle.
Caution
Care should be taken in the event battery case is
cracked or leaking to protect hands from the electro-
lyte. A suitable pair of rubber gloves
hold type) should be worn when removing battery by
hand.
3. Inspect battery carrier for damage caused by loss of acid
from battery. If acid damage is present, it will be necessary
to clean area with a solution of clean warm water and
baking soda. Scrub area with a stiff bristle brush and wipe
off with a cloth moistened with ammonia or baking soda in
water.
4. Clean top of battery with same solutions as described in
Step (3).
5. Inspect battery case and cover for cracks. If cracks are
present, battery must be replaced.
6. Clean the battery post with a suitable battery post cleaning
tool.
7. Clean the inside surfaces of the terminal clamps with a
suitable battery terminal cleaning tool. Replace damaged or
frayed cables and broken terminals clamps.
8. Install the battery in vehicle.
9. Connect (+) and (-) cables to battery in the order of
mention.
TSB Revision
(not
the house-