Mitsubishi Electric 55624R(S)-MF Service Manual page 34

METERS AND GAUGES - Meters and Gauges
SERVICE POINTS OF REMOVAL
3. REMOVAL OF THE COMBINATION METER
(1) Remove the mounting screws; then remove the
(2) For models equipped with the automatic position
4. REMOVAL OF ADAPTER
(1) Disconnect the speedometer cable at the transmission
(2) Pull the speedometer cable slightly toward the vehicle
INSPECTION
REED SWITCH INSPECTION
Use circuit tester to check circuit repeats off/on between
terminals when speedometer shaft turned several times.
FUEL GAUGE CIRCUIT INSPECTION
Measure resistance between terminals with circuit tester.
Standard value:
A - B
A - C
ENGINE COOLANT TEMPERATURE GAUGE CIRCUIT IN-
SPECTION
Measure resistance between terminals with circuit tester.
Standard value:
Vehicles built up to Dec. 1988
Vehicles built from Jan. 1989
I
combination meter by turning the upper part of it
toward the front.
indicator, disconnect the harness connector before
removing the combination meter.
end of the cable.
interior, release the lock by turning the adapter to the
left or right, and then remove the adapter.
Approx. 203 Q
Approx. 102 52
Approx. 102 52
A - B Approx. 130 Q
A - C Approx. 53 Q
Approx. 162 Q
B-C
A - B Approx. 146 S2
A - C Approx. 60 B
Approx. 206 Q
B - C