Mitsubishi Electric 55624R(S)-MF Service Manual page 29

METERS AND GAUGES - Service Adjustment Procedures
stopper
Drum
Reference value
Front trac
hook
Front
SERVICE ADJUSTMENT PROCEDURES
INSPECTION
SPEEDOMETER INSPECTION
NOTE
For AWD models, refer to the section concerning special
handling instructions for AWD models in GROUP 00.
Take note of the following before inspection:
(1) Assure tire pressure at standard value.
(Refer to GROUP 31 -Specifications.)
make sure the center line of the vehicle is at right angles to
the center line of the drum. Also, make sure the drum is
positioned so as to center between the front tires.
Rear wheel safety procedures
from moving. Secure the stoppers to the floor, or take
measures to prevent the stoppers from slipping.
(2) Make sure the parking brake has been set.
Front wheel away prevention procedure
ends of both bars to anchor plates.
(2) Make sure the tension on the right and left bars is the
same. Also be sure there is enough tension on each bar.
Accident prevention procedures
the end of the wire or chain is secured firmly.
Use a speedometer tester to measure the speedometer's
indication error.
Standard value:
Standard indication
20
40
60
80
100
TSB Revision
54-29
Allowable range
38-44
57-66
76-88